Printer infusion

printer infusion
one of the weaknesses in the infusion printer is
problem of air trapped in the IV. Of course this will result in the smooth flow of ink from the IV tube into the cartridge. and consequently the print to be imperfect, eg prints dotted, striped, there are colors that do not come out, and so on. if you have this .... sometimes we become dizzy ......

Now his question is ... Why Air can enter the IV Canon?
The air in the IV Canon is caused by the gap between the hole and the rubber catrid place the IV drip into the cartridge. Or more trivial, hose connections and catrid "loose". This vulnerability occurs because the hole is not in accordance with the rubber catrid, because at the moment only with solder catrid punch / drill bit that does not match the diameter of the rubber and knee infusion. Consequently, over time the air will be entered into the IV.
Tools For Overcoming Air Hose Infusion In Canon:

glue
Vacuum Toolkit Catrid Canon
How to Solve Indoor Air Hose Infusion Canon:

Prepare  glue (do not use hard glue , can damage plastic)
Take off the hose and do Catrid IV.
Glue the edges catrid hole where the hose comes in, try not to get in the air.
Allow the glue to dry first.
Open Close breathing tube Infusion
Prepare Toolkit Vacuum Catrid Canon, then Install Catrid the Toolkit.
Attach the syringe / injection without a needle into the rubber hole on the bottom of Vacuum Catrid Toolkit.
Then suck the ink through the air in the hose is lost.
The printer is Ready.