These tips can be used to type laserjet printer users.
These tips can be used to type laserjet printer users.
1. Note the voltage / electric power. Most printers are damaged due to the absence of a stable electrical protection, try using a stabilizer with a servo motor system.
2. Never try to force revoke paper JAM / jammed with force, if necessary, try to pull in the direction of the paper come out at the time the printer prints, but it would be better if you immediately took him to the place of service, rather than forced and had to replace spare parts, typically a subject is part of the movie, and gear to easily fall out or damaged at the time the paper is pulled with force.
3. Keep the flakes "strapless wire" not to fall on the tray / paper place, or holes of the printer, this is because heating technology the printer uses a plastic film, so it will be easier once torn apart if hit by sharp objects, and the resulting paper blisters and prints are not perfect (there bercaknya).
4. If you've finished using the printer, immediately turn off. Do not turn on the printer for too long, let alone all night when not in use, plus if you use the printer is plugged directly into electricity without the stabilizer.
5. If you want to print something on any other media containing plastic materials, such as stickers or transparent paper, make sure first that the media is heat resistant. If the media is not resistant to heat, the media, it can melt / melt in the printer and will cause damage. My advice, try using the original media from the manufacturer, such as using paper / other media-made genuine HP.
6. Never force a toner that has been leaked to print, this will cause the accumulation of toner grains on heating, which eventually resulted in the attachment of the toner is in the heating and roller of the printer. Later, the printer will be disabled when a print job.
7. Try to keep every 5-6 months once your printer in the service. The goal is to clean the inside of the grain powder toner.
1. Note the voltage / electric power. Most printers are damaged due to the absence of a stable electrical protection, try using a stabilizer with a servo motor system.
2. Never try to force revoke paper JAM / jammed with force, if necessary, try to pull in the direction of the paper come out at the time the printer prints, but it would be better if you immediately took him to the place of service, rather than forced and had to replace spare parts, typically a subject is part of the movie, and gear to easily fall out or damaged at the time the paper is pulled with force.
3. Keep the flakes "strapless wire" not to fall on the tray / paper place, or holes of the printer, this is because heating technology the printer uses a plastic film, so it will be easier once torn apart if hit by sharp objects, and the resulting paper blisters and prints are not perfect (there bercaknya).
4. If you've finished using the printer, immediately turn off. Do not turn on the printer for too long, let alone all night when not in use, plus if you use the printer is plugged directly into electricity without the stabilizer.
5. If you want to print something on any other media containing plastic materials, such as stickers or transparent paper, make sure first that the media is heat resistant. If the media is not resistant to heat, the media, it can melt / melt in the printer and will cause damage. My advice, try using the original media from the manufacturer, such as using paper / other media-made genuine HP.
6. Never force a toner that has been leaked to print, this will cause the accumulation of toner grains on heating, which eventually resulted in the attachment of the toner is in the heating and roller of the printer. Later, the printer will be disabled when a print job.
7. Try to keep every 5-6 months once your printer in the service. The goal is to clean the inside of the grain powder toner.
Komentar